Cable clip on slatwall, holding a phone cable

Building…

Cable clip for slatwall

Not test-printed yetBuilding…

Colours

Puts this design back in its own colours. Designs you haven't coloured show their own colours too, until you pick new ones.

Set your own measurements

Size

Clip width

Width along the slot. 25.4 mm (1 in) is the print-tested mount width

What it holds

Clip opening

The paper stack's thickness or the cable's diameter. The spring leaf pinches the mouth narrower than this, so a stack is gripped and a cable snaps in. Thinnest stack it grips: about 1 mm (10 sheets)

Clip depth

How far the paper or cable drops in. It is never less than the opening plus 6 mm, so a cable always sits below the pinch

Holds: Cables
Kind: Paper & cable clip
Prints as: One piece
Needs: Nothing to buy

Print settings, already in the 3MF

Worked out from your setup once the part has built.

Cable clip

Holds: Cables

Prints as 1 piece

Holds a paper stack, a manual or a cable on the wall in a small spring clip. Push it down into the mouth and a bump grips it; pull it up to take it out. It grips stacks from about 1 mm, not one sheet; print in PETG or ASA for an unheated garage.

CC BY 4.0 · Free

Not test-printed yet. Made with AI and checked against the rules on every wall, but no test print has confirmed it yet.

Walls it fits

VEVOR PVC slatwallFits · some wall sizes assumed · not test-printed yet
StoreWallFits · not test-printed yet
HandiwallFits · some wall sizes assumed · not test-printed yet
Trusscore SlatWallFits · not test-printed yet
Retail MDF slatwall, 3 inFits · not test-printed yet
Flow WallFits · some wall sizes assumed · not test-printed yet
Gladiator GearWallWon't fit: its slot opening is 17 mm, and the cam-lock mount needs a slot opening from 8.5 to 11 mm
ProSlat PVC slatwallWon't fit: ProSlat doesn't publish its slot. Measure your wall and use Custom

History

First published 8 Oct 2026 1.0.4

More for cables

Everything for cables ›